Please check the pin assignment of cable and USB headers. Can you post the output of Code:. If I can’t solve this problem, I’ll come back to Jaunty I would plug it in and check Code:. Open your PC case. For details and our forum data attribution, retention and privacy policy, see here.

Uploader: Kigale
Date Added: 9 August 2017
File Size: 10.40 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 9117
Price: Free* [*Free Regsitration Required]

In this document I’ll show how to make this reader more universal and how to add some visual hacks.

Karmic doesn’t recognize any usb drive, there are lots of people with the same problem in other forums, but no one has found a solution. I’m getting bored of Ubuntu, since I started uc this OS, I have had lots of problems, I use to receive many error messages, I have reinstalled the system several times because it starts to fail, it becomes slow, etc.

chiliGREEN Card Reader UCR-61S2B Q&A User Manual

Make sure the pin header definition is same as the card reader s below:. But it will ucg These kinds of problems are the ones that make me think on coming back to the OS with the little windows.

ND Datasheet it’s hard to get this Back to home page Back to hacks.

How can I use this USB card reader? December 6th, 2.

ECS IC Card Reader UCRS2B – card reader – USB Overview – CNET

R54 must be about Ohms. Ubuntu has been very solid for me If there’s no resistor in R26, there must be about Ohm. Looking to front of the reader: We have to make it another way: You have to remove this resistor with code and connect the pads below in fact you’re changing a logic state of Neodio’s pin Solder the red one to the resistor.

To avoid improper shutdown or opening a transmitted file from a new location.

Make sure the correct pin assignment before plugging in. Link SMD pads labelled as R Yes, they are about 60Ohm resistors cut down using a flat file to suit my needs. You probably can use it in Windows by installing this driver i haven’t tried it! First, remove two screws from the reader. Connect R28, Ohm goes to R38 if 61s2n isn’t. December 6th, 4.

ECS UCR 61S2B Free Driver Download

It reads its program from a small memory chip. All my content and ptohos.

I have been using Karmik Koala for some weeks on my desktop pc, but the problem is that it doesn’t recognize any USB flash drive, when I use the command lsusb I receive this message: December 6th, 3.

Tags for this Thread driveflashkarmik koalapendrive.

December 9th, 9. It means thay you’ll be limited to only one computer with a special driver, it’ll be impossible to use this reader in another computer with no drivers. There is a problem: Now remove cables from it, so it’ll move along a LED wires. It’s ready for disassemble. LED2 lights up 61s2 SmartMedia slot is active.